The 1988 Acura Integra Service Manual provides comprehensive technical information for maintaining and repairing the 1988 Acura Integra. This manual covers engine systems, transmission, suspension, brakes, electrical systems, heating and air conditioning, body components, and routine maintenance procedures. Below are key sections for specifications, maintenance schedules, troubleshooting, and repair procedures.
Technical specifications for the 1988 Acura Integra including engine, dimensions, capacities, and performance data.
| Specification | Details |
|---|---|
| Engine Type | 1.6L DOHC 16-valve inline-4 |
| Displacement | 1590 cc |
| Horsepower | 113 hp @ 6250 rpm |
| Torque | 99 lb-ft @ 5500 rpm |
| Transmission | 5-speed manual / 4-speed automatic |
| Fuel System | Multi-point fuel injection |
| Fuel Capacity | 13.2 gallons |
| Curb Weight | 2380 lbs |
| Wheelbase | 96.5 inches |
| Brakes | Front disc / rear drum |
Recommended maintenance intervals for optimal vehicle performance and longevity.
WARNING! Always use genuine Acura parts for optimal performance and warranty compliance.
Detailed procedures for engine maintenance, repair, and troubleshooting.
CAUTION! Always disconnect battery before working on electrical components.
Front and rear suspension components, alignment specifications, and steering system service.
Front Suspension: MacPherson strut replacement, control arm service, ball joint inspection
Rear Suspension: Double wishbone system, shock absorber replacement
Steering: Power steering pump service, rack and pinion inspection, tie rod replacement
Alignment Specs: Camber: -0°30' ± 1°, Caster: +1°45' ± 1°, Toe: 0 ± 2mm
Complete brake system service including hydraulic systems, parking brake, and ABS components.
Tip: Always replace brake components in axle sets for balanced braking performance.
Battery, charging, starting, lighting, and accessory electrical systems.
WARNING! Disconnect battery negative terminal before performing electrical work.
Climate control system service including compressor, evaporator, and heater core.
| Component | Service Procedure |
|---|---|
| A/C Compressor | Replacement and clutch gap adjustment |
| Evaporator | Cleaning and replacement procedures |
| Heater Core | Flushing and replacement guide |
| Blower Motor | Testing and replacement steps |
| Refrigerant | R-12 specifications and charging procedures |
Body panel alignment, interior trim, glass, and latch mechanisms.
Body Repair: Panel replacement, paint codes, and corrosion protection
Interior: Seat removal, dashboard components, trim panel service
Glass & Seals: Windshield replacement, weatherstrip installation
Locks & Latches: Door lock mechanism service, key cylinder replacement
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Engine won't start | Fuel pump, ignition, battery | Check fuel pressure, spark, battery voltage |
| Poor fuel economy | O2 sensor, air filter, tire pressure | Replace O2 sensor, check air filter, inflate tires |
| Brake vibration | Warped rotors, worn pads | Resurface or replace rotors, install new pads |
| Electrical issues | Alternator, battery, grounds | Test charging system, clean battery terminals |
| Overheating | Thermostat, radiator, water pump | Replace thermostat, flush cooling system |
Complete electrical schematics for all vehicle systems including color-coded wiring, connector locations, and ground points.
Service Support: Contact Acura customer service at 1-800-382-2238 for technical assistance.