1987 Land Cruiser Manual PDF

The 1987 Toyota Land Cruiser is a legendary 4x4 SUV known for its rugged durability and off-road capabilities. This comprehensive manual covers the FJ60 and FJ62 models with 4.2L inline-6 engine, 4-speed manual transmission, part-time 4WD system, and all essential maintenance procedures. Below are key sections for specifications, operation, maintenance, troubleshooting, and technical details.

1. Vehicle Specifications 2. Controls and Instrumentation 3. Engine and Drivetrain 4. 4WD System Operation 5. Routine Maintenance 6. Electrical System 7. Brake System 8. Suspension and Steering 9. Troubleshooting Guide 10. Technical Diagrams 11. Service Intervals

Vehicle Specifications

Key specifications for the 1987 Toyota Land Cruiser models FJ60 and FJ62.

Specification	Details
Engine	4.2L 2F inline-6 cylinder
Displacement	4230cc (258 cu in)
Horsepower	135 hp @ 4000 rpm
Torque	210 lb-ft @ 1800 rpm
Transmission	4-speed manual H41/H42
Transfer Case	Part-time 2-speed
4WD System	Part-time with manual locking hubs
Fuel Capacity	25 gallons (95 liters)
Wheelbase	107.5 inches
Curb Weight	4,300 lbs (FJ60)

Controls and Instrumentation

Dashboard layout and control functions for proper vehicle operation.

Ignition switch: Start position with key rotation
Transfer case lever: 2H-4H-N-4L positions
Manual locking hubs: Free/Lock positions
Instrument cluster: Speedometer, fuel gauge, temperature, oil pressure
Heater controls: Three-knob system for fan, temperature, and vent selection

WARNING! Engage 4WD only on slippery surfaces to avoid drivetrain damage.

Engine and Drivetrain

The 2F engine features single overhead cam, 7 main bearings, and carbureted fuel system.

Engine oil capacity: 7.4 quarts with filter
Coolant capacity: 13.5 quarts
Transmission oil: 3.2 quarts (manual)
Transfer case: 2.6 quarts
Differentials: 3.5 quarts front, 3.8 quarts rear

CAUTION! Use only recommended SAE 10W-30 oil and Toyota Red coolant.

4WD System Operation

2H (2WD High): Normal driving on dry pavement
4H (4WD High): Slippery roads up to 50 mph
N (Neutral): Disengages drivetrain for towing
4L (4WD Low): Extreme off-road or heavy pulling
Manual Hubs: Must be locked for 4WD operation

Routine Maintenance

Scheduled maintenance procedures and inspection points.

Oil Change: Every 3,000 miles or 3 months. Air Filter: Inspect every 15,000 miles. Spark Plugs: Replace every 30,000 miles. Coolant: Replace every 2 years. Brake Fluid: Replace every 2 years. Differential Oil: Change every 15,000 miles in severe service.

Electrical System

12-volt negative ground system with 60-amp alternator.

Battery: Group 27, 12V 65Ah
Alternator output: 60 amps at 2000 rpm
Fusible links: Protect main circuits
Lighting: Sealed beam headlights, separate turn signals

Tip: Check fusible links before diagnosing electrical issues.

Brake System

Front disc and rear drum brakes with vacuum booster.

Brake fluid: DOT 3
Master cylinder: Tandem type with reservoir
Front pads: Replace when worn to 1mm
Rear shoes: Adjust periodically
Parking brake: Mechanical rear drum type

WARNING! Bleed brakes thoroughly after any line service.

Suspension and Steering

Solid front and rear axles with leaf spring suspension.

Recirculating ball steering gear with hydraulic power assist. Front axle: Semi-floating with birfield joints. Rear axle: Semi-floating full-floater. Spring rates: Progressive leaf design. Shock absorbers: Hydraulic double-acting.

Troubleshooting Guide

Common issues and diagnostic procedures.

Symptom	Possible Cause	Corrective Action
Hard starting	Carburetor issues	Check choke operation, fuel pump pressure
4WD won't engage	Vacuum system	Check vacuum lines to transfer case
Oil consumption	Valve guides/seals	Compression test, inspect valve seals
Steering play	Worn components	Check tie rods, steering gear adjustment
Brake pull	Calipers/cylinders	Inspect front calipers, rear wheel cylinders

Technical Diagrams

Reference diagrams for maintenance and repair.

Vacuum line routing, electrical schematics, brake system layout, suspension components, engine bay overview, transmission linkage, transfer case internals, differential assembly, fuel system diagram, cooling system flow.

Service Intervals

Recommended maintenance schedule for optimal performance.

Every 3,000 miles: Engine oil and filter change. Every 6,000 miles: Lubricate chassis, check brakes. Every 15,000 miles: Air filter, differential oils. Every 30,000 miles: Spark plugs, coolant, transmission oil. Every 60,000 miles: Timing chain inspection, valve adjustment.

Service: Consult Toyota dealership for genuine parts and technical support.