1987 Honda Goldwing Interstate Owners Manual

The 1987 Honda Goldwing Interstate is a touring motorcycle featuring a 1182cc liquid-cooled horizontally opposed four-cylinder engine, shaft drive, full fairing with integrated storage compartments, adjustable suspension, comprehensive instrumentation, and touring-specific amenities. Below are key sections for safety, features, maintenance, operation, and troubleshooting.

Features at a Glance

Key components: 1182cc engine, full fairing with lowers, integrated saddlebags, adjustable air suspension, comprehensive dash instrumentation.

Pre-Ride Inspection

Always perform pre-ride inspection before operating motorcycle.

1. Check tire pressure and condition: Front 36 psi, Rear 41 psi (solo riding)
2. Verify fluid levels: Engine oil, coolant, brake fluid, final drive oil
3. Test lights and signals: Headlight, brake light, turn signals, horn
4. Check brake operation: Front and rear brake lever/pedal function
5. Inspect chain/shaft drive: Ensure proper lubrication and tension

WARNING! Failure to perform pre-ride inspection may result in accident or injury. Always wear proper protective gear.

Controls and Instrumentation

Left handlebar: Clutch lever, turn signals, horn, high/low beam. Right handlebar: Throttle, front brake, engine kill switch, starter.

Dashboard: Speedometer, tachometer, fuel gauge, coolant temperature, gear indicator, warning lights (oil pressure, neutral, turn signals).

Adjustable features: Air suspension controls, fairing wind deflectors, handlebar position, seat height. Storage: Saddlebag locks, fairing compartments, trunk capacity.

Specifications

• Engine: 1182cc liquid-cooled horizontally opposed four-cylinder
• Power: 94 hp @ 6500 rpm
• Torque: 78 lb-ft @ 4500 rpm
• Transmission: 5-speed manual with electric overdrive
• Final Drive: Shaft
• Fuel Capacity: 6.3 gallons
• Weight: 794 lbs (wet)
• Seat Height: 31.5 inches
• Brakes: Dual disc front (276mm), single disc rear (296mm)
• Tires: Front 130/90-17, Rear 150/90-15

Routine Maintenance

Follow maintenance schedule for optimal performance and longevity.

1. Oil change: Every 4,000 miles or 6 months
2. Oil filter: Replace with every oil change
3. Air filter: Clean every 8,000 miles, replace every 16,000 miles
4. Spark plugs: Replace every 8,000 miles
5. Coolant: Replace every 2 years or 16,000 miles
6. Brake fluid: Replace every 2 years
7. Final drive oil: Replace every 8,000 miles
8. Tire inspection: Check pressure weekly, inspect for wear

CAUTION! Use only Honda Genuine parts and recommended fluids.

Riding Operation

Starting procedure, shifting, and touring operation guidelines.

1. Starting: Turn key ON, ensure neutral, pull clutch, press starter
2. Warm-up: Allow engine to reach operating temperature before riding
3. Shifting: Smooth clutch operation, proper RPM matching
4. Braking: Use both brakes, progressive pressure application
5. Suspension: Adjust air pressure for load and road conditions
6. Fueling: Use unleaded gasoline (87 octane minimum)

Tip: Practice emergency braking and maneuvering in safe area.

Storage and Care

Proper storage procedures for seasonal or long-term parking.

1. Fuel system: Add fuel stabilizer, run engine to circulate
2. Battery: Disconnect or use maintenance charger
3. Tires: Inflate to maximum pressure, lift off ground if possible
4. Cleaning: Wash and wax, apply protectant to rubber and plastic
5. Cover: Use breathable motorcycle cover
6. Location: Store in dry, temperature-stable environment

WARNING! Do not store with fuel in carburetors without stabilizer.

Troubleshooting

Service: Contact authorized Honda dealer for complex issues.

Warranty Information

12-month unlimited mileage warranty from date of purchase. Covers defects in materials and workmanship. Excludes normal wear items, improper maintenance, accidents, or modifications. Keep maintenance records for warranty claims. For warranty service, contact authorized Honda dealer with proof of purchase.